The new Logicor InLine Hot Water System is powered by electricity and is designed to replace your existing water boiler and storage tank in your home. If you also have our Clear Heater System installed it will remove the need for gas in your home altogether.

The InLine Hot Water System will complement the Clear Heater System in your home or office by providing efficient hot water on demand, and just like the Clear Heater System you’ll have full control of how much you spend on hot water on a daily or monthly basis via the smart Control Panel.

The new system replaces both the traditional boiler and the storage tank in your home removing the need for gas in your home altogether when combined with the Clear Heater System.

  • Max Power: 12kW
  • Normal operating power: 6kW
  • Max operating pressure: 4 bar
  • Output flow: 6 litres/min (software controlled)
  • Dimensions: 500 x 470 x 90 mm
  • Weight: 15 kg
  • Colour: Gloss white and chrome.
Download Brochure

From the 6th April 2010 the Building Regulations Part G limits the amount of estimated water use in new dwellings to 125 litres per day per person.

The aim is to improve water efficiency. Revisions in 2015 provide an alternative to calculating the water  consumption based on the maximum water flow from water fittings. Where the fittings approach is used, the water consumption of the fittings provided must not exceed set values; for example 6 litres per minute for a bath.

Logicor’s InLine Hot Water System meets these requirements by setting a maximum flow rate of hot water to 6 litres per minute.

Download the Building Regulations Part G

The InLine Hot Water System has been designed and built with a focus on quality and safety and meets all relevant requirements of applicable product safety directives.

The EC Declaration of Conformity Certificate is a sign that the ILHWS has been designed and constructed for compliance with relevant essential requirements, and has been through the appropriate conformity assessment processes.

Download EC Declaration of Conformity Certificate.

The Building Regulations 2010, Part G – Sanitation, hot water safety and water efficiency

The Royal Society for the Prevention of Accidents (RoSPA) fought a long and successful campaign to prevent horrific bath water scalds in homes across the UK. The result was an amendment to the Building Regulations which came into effect on 6th April 2010. All new-build homes across England and Wales after that date must have devices fitted to baths to limit the temperature of the water to 48°C. That temperature is still more than hot enough for domestic use, but it removes the potential for the most serious scald injuries to happen.

“The hot water supply temperature to a bath should be limited to a maximum of 48°C by use of an in-line blending valve or other appropriate temperature control device, with a maximum temperature stop and a suitable arrangement of pipework.”​

Logicor’s InLine Hot Water System fully complies with the new regulations, having a maximum temperature set at 46°C, a full 2°C below the safety level.

Download the original document here.

Frequently Asked Questions

Do I need to have the Clear Heater System/ Smart Control Pad?

The InLine Hot Water Unit can be run independently as a “stand alone unit” using the on board controls or programmed to work in conjunction with the Logicor Smart Control Panel.

Can the hot water unit be installed in areas with hard water?

A water filter is supplied with all units and must be fitted in all instances to maintain the performance of the system.